Borfly Thermal Insulating Plaster

Based on 0 reviews. - Write a review

5.000K.D

Qty

Add to Cart

APPLICATION AREAS:

It can be easily used in rough and fine plaster, brick, concrete, bims

block, briquet, aerated concrete, roof and basement columns and beams

under gypsum wood laminate and parquet floors.

SURFACE PREPARATION:

The roughness which will prevent application on the applied floor

should be removed, the swollen paint must be free from lime, powder

paint, mold oil. Cracks and holes on the surface should be covered

with repair mortars. Prepared transfer lining is prepared for the soils

that are specially produced.

HANDLING INSTRUCTIONS:

After mixing, first add water and then borfly

special insulation. 16 kg of kraft bag is discharged onto 15-16 lt water.

In order to get a good consistency from the mixture, the sides of the

container should be peeled off with the help of the trowel and mixed

again. When mixing the product, 800-1200 rpm mixers and mixers

should be used for good homogeneity. Mixing time is about 2-3 minutes

until the mixture is mixed until the mixture is completed, the

product is rested for 2-3 minutes after the mixers are mixed again and

passed to the application. If the product starts to get sockets during

use, the product will be mixed again and nothing will be added.

APPLICATION CONDITIONS:

Application ambient temperature: +5 to 35 degrees. Do not apply to

surfaces that are frozen or dangerous to frost within 24 hours. Do not

apply to hot surfaces under severe sun and wind.

APPLICATION:

The boreholes are installed at certain intervals so as not to exceed the

size of the gauge to be used. Prepared BORFLY special insulation plaster

is filled with steel trowel or machine between the anos. It is applied

to not exceed 8-10 mm thickness. The first layer of drying time should

be 36-48 hours. At the end of this training a second layer application

is made. Afterwards, the last layer of mortar is poured into the steel

material and BORFLY special heat insulation layer is completed.

STORAGE AND TRANSPORTATION:

Packaging should be stacked for 12 years at maximum

cool, undisturbed environment.

SAFETY WARNINGS:

Powder mask and gloves should be used during the product mix. Eye

should be washed with plenty of water